CHARACTERISTICS:

Rugged stainless steel construction
Virtually double pedal control and feed accuracy due to double action pedal arm design
The heel can move up/down with the foot, resulting in excellent pedal control and advance accuracy
Fully adjustable pedal surfaces and heel supports for optimal pedal feel and ergonomics
Load cell in all pedals for throttle, brake and clutch
Brake: 200 kg load cell / maximum load through the foot: 100 kg
Silent operation due to the use of ball bearings and spherical rod ends
Maintenance free: no lubrication required
Installation pattern (click to open): 87 mm (lateral) x 80 mm (longitudinal)
⇒ Can be mounted directly on aluminum profiles (minimum 40×120 mm)
Adjustable pedal tilt angle +8 / -16 degrees.
Super easy and quick adjustment of pedal travel, pedal feel and required actuation force
Adjustable max. compression for each polyurethane spring in 1 mm increments
Adjustable brake travel limiter (does not limit load, only travel)
12 bit resolution
Calibration software with
adjustable dead zones
Non-linear response curves
Save to file and load from file for profiles
Pedal-to-controller box cable lengths: Brake 35 cm, Throttle 25 cm
Double shielded USB cable
Controller box equipped with mounting holes (M4)
Can be mounted directly to an industry standard 80/20 aluminum profile (min. 40×120 mm or 2 separate profiles)
Designed, manufactured and assembled in Finland 🇫🇮.
Warranty: 2 years

INCLUDING:

Controller box + USB cable
Polyurethane elastomers: 4 x L=15 mm (installed) | 5 x L=10 mm
1 x steel spring L=51 mm
Grounding cable (use only if necessary)
Grip strap for brake pedal
4x M6 T-nut (for fastening to aluminum profile) for each pedal + 4x M6-16 screws + washers
2x M4 T-nut for controller box + M4-25 screws
Additional washers